Table of Contents
Advertisement
52
EcoSystem
Stand-Alone Occupant Sensor Setup
An occupant sensor adjusts the light level based on whether the
space is occupied or unoccupied. For more information, refer to
page 20.
1 1 From the Stand-Alone
Programming menu, select
S S e e n n s s o o r r S S e e t t u u p p .
NOTE: For procedures on how to
access the Stand-Alone
Programming menu, refer to
page 47.
2 2 Select O O c c c c u u p p a a n n t t S S e e n n s s o o r r .
3 3 Use the up and down
Occupied Level arrows to
adjust the occupied light level.
The intensity of the lights will
change as you make
selections during steps 3 and
4 of this procedure.
4 4 Use the up and down
Unoccupied Level arrows to
adjust the unoccupied light
level.
5 5 Select D D o o n n e e .
6 6 To continue configuring
settings on the current ballast,
select C C o o n n t t i i n n u u e e S S e e t t t t i i n n g g U U p p
B B a a l l l l a a s s t t . Otherwise, select
D D o o n n e e to return to the Main
menu.
Programmer
®
1 1
2 2
3 3
4 4
5 5
Advertisement
Table of Contents
