56
EcoSystem
Manually Adjusting the Light Level
The light level can be manually adjusted for all fixtures in an IR
receiver group. The adjusted light level remains in effect until one of
the following occurs:
• An emergency situation occurs
• A daylight sensor lowers the fixture to compensate for natural
lighting
• The room becomes unoccupied, or
• A user manually adjusts the level again via EcoSystem
programmer, wall control, or IR tramission.
1 1 From the M M a a i i n n M M e e n n u u , tap
L L i i g g h h t t i i n n g g C C o o n n t t r r o o l l .
2 2 Read the instructions, then
tap
to continue.
3 3 To control only the fixture(s)
assigned to the sensor, select
I I R R R R e e c c e e i i v v e e r r W W a a l l l l C C o o n n t t r r o o l l
G G r r o o u u p p .
To control all fixtures,
overriding other sensor inputs,
select A A l l l l B B a a l l l l a a s s t t s s . (The
override will end after 15
minutes of inactivity, unless
exited manually.)
4 4 Point the programmer at the
IR receiver whose group
fixture(s) are to be adjusted (or
any IR receiver if all fixtures are
being controlled), then tap a
light level.
5 5 Tap M M a a i i n n M M e e n n u u or
Programmer
®
to exit.
1 1
4 4
5 5