12
EcoSystem
Addressing the System
Prior to programming, each ballast must be addressed. This enables
the programmer to communicate with the ballasts and program their
settings.
NOTE: To address new ballasts added to an existing system, refer to
page 60.
1 1 From the Main Menu, tap
S S y y s s t t e e m m . .
2 2 Tap R R e e s s e e t t & & A A d d d d r r e e s s s s N N e e w w
S S y y s s t t e e m m .
3 3 Read the instructions, then
tap
to continue.
NOTE: Occupant sensors do not
have integrated IR receivers.
4 4 Tap
to continue.
C C a a u u t t i i o o n n ! ! System will be set to
factory defaults.
5 5 Tap
to confirm the reset.
(Or tap
6 6 If all ballasts flash 3 times, tap
. Otherwise, tap
NOTE: If fixtures do not flash, the
signal from the programmer did
not reach the IR control device.
Refer to page 4 for details.
7 7 Tap
to address the
system.
8 8 Tap
to begin addressing.
Programmer
®
to C C a a n n c c e e l l .)
.
2 2
5 5