Setting The Contact Closure Occupancy Timeout - Lutron Electronics EcoSystem Programmer Programming Manual

Setting the Contact Closure Occupancy Timeout

The occupancy timeout setting specifies the number of minutes
before a fixture group turns off after contact closure input.
1 1 From the Contact Closure
Setup menu, tap C C o o n n t t a a c c t t
C C l l o o s s u u r r e e C C l l o o s s u u r r e e S S e e t t u u p p .
NOTE: For procedures on how to
display the Contact Closure
Setup menu, refer to page 41.
2 2 Select C C o o n n t t a a c c t t C C l l o o s s u u r r e e 1 1 or
C C o o n n t t a a c c t t C C l l o o s s u u r r e e 2 2 .
3 3 If a group of ballasts goes to
full brightness and other
ballasts go to minimum
brightness, tap
4 4 Select S S e e t t T T i i m m e e o o u u t t . .
5 5 If ballasts go to their occupied
level, tap
6 6 Select the number of minutes
until the fixture group turns off
after contact closure input.
7 7 Select D D o o n n e e .
8 8 Select D D o o n n e e . . Or, select
another option to continue
configuring ballasts.
9 9 When done, if the last
configured ballast(s) flash and
go to their high level, tap
.
.
Programming Guide
.
45
1 1
4 4
6 6
7 7