Table of Contents
Advertisement
Accessing the Stand-Alone Programming Menu
The stand-alone programming menu enables you to configure
special settings for ballasts and modules used in a stand-alone
configuration.
1 1 From the Main Menu, tap
B B a a l l l l a a s s t t s s then S S t t a a n n d d - - A A l l o o n n e e
P P r r o o g g r r a a m m m m i i n n g g . Acknowledge
the note regarding stand-alone
programming, and tap
continue.
2 2 Read the instructions. Point
the programmer at an IR
control device connected to
the ballast to be configured,
then tap
3 3 Point the programmer at the IR
control device and tap
begin communication.
The Stand-Alone Programming
menu displays and you can:
• Set the emergency level
• Set the high end trim
• Perform stand-alone lamp
seasoning
• Set up a daylight or
occupancy sensor, or
configure XPJ settings
• Enable or disable 3 wire
input
• Reset the selected ballast
Refer to the following topics for
detailed stand-alone
programming procedures.
to continue.
Programming Guide
to
to
47
1 1
Advertisement
Table of Contents
