Setting Up Scenes For Wall Controls - Lutron Electronics EcoSystem Programmer Programming Manual

26
EcoSystem

Setting Up Scenes for Wall Controls

Wall controls can be set up to activate scenes (preset light levels). A
different scene can be configured for each button on the control.
Note that all wall controls in a given group will operate the same.
1 1 From the Main Menu, tap
D D e e v v i i c c e e S S e e t t u u p p and then
I I R R R R e e c c e e i i v v e e r r / / W W a a l l l l C C o o n n t t r r o o l l .
2 2 Read the instructions, then
tap to continue.
3 3 Point the programmer at any
IR receiver and tap
begin communication.
4 4 If all fixtures go to minimum
brightness and a fixture
connected to a wall control
flashes, tap
5 5 Scroll to the wall control to be
set (its group of fixtures will
flash). Tap
selected control.
6 6 Select S S i i n n g g l l e e B B a a l l l l a a s s t t or A A l l l l
B B a a l l l l a a s s t t s s and tap
7 7 If the ballasts flash and then
go to a scene level, tap
8 8 Select the number of the
scene to be set (scene 1
matches the first button on the
control, scene 2 matches the
second button, and so on).
9 9 If fixtures for this control go to
their selected scene level, tap
.
Programmer
®
to
.
to configure the
.
.
1 1
5 5
6 6