Replacing Ballasts - Lutron Electronics EcoSystem Programmer Programming Manual

58
EcoSystem

Replacing Ballasts

If a ballast needs to be replaced, enter the serial numbers from the
old and new ballast into the programmer. All settings of the old
ballast will be applied to the new ballast and the need for
reprogramming is eliminated.
NOTE: If a single ballast is being replaced, and Automatic Ballast
Replacement is enabled (the default setting), it is not necessary to
manually enter serial numbers. Refer to page 61 for details.
1 1 From the Main Menu, tap
B B a a l l l l a a s s t t s s and then R R e e p p l l a a c c e e
B B a a l l l l a a s s t t .
2 2 Read the instructions, then
tap to continue.
3 3 Point the programmer at any
IR control device, then tap
4 4 If fixtures for a receiver flash
and others go to minimum
brightness, tap
5 5 Use the keypad to enter the
14-digit serial number of the
old (replaced) ballast, then tap
.
The old ballast does not need
to be powered on or
connected to the system.
NOTE: To backspace, tap
6 6 Enter the 14-digit serial
number of the new ballast.
Then tap
The new ballast must be
powered on and connected to
the system.
Programmer
®
.
.
.
.
5 5
6 6