Table of Contents
Advertisement
14
EcoSystem
Configuring Areas
Areas allow a number of fixtures and their associated sensors to be
quickly grouped together. If fixtures are added or removed from an
area, sensors within the area are automatically assigned to control
them, overriding any preexisting grouping in the area. If multiple
daylight sensors are in the area, only one is assigned. Once
created, areas can be modified through the normal sensor grouping
means. Any area can be configured from any IR receiver. It is not
necessary to directly access a sensor within the area being created.
1 1 From the Main Menu, tap
G G r r o o u u p p i i n n g g and then A A r r e e a a .
2 2 Read the instructions, then tap
to continue.
3 3 Point the programmer at any
IR control device and tap
to begin communication.
4 4 If a single fixture flashes, then
fixtures in area 1 go to full
brightness and other fixtures
go to minimum brightness,
tap
.
NOTE: If all fixtures flash three
times and then go to minimum
brightness, area 1 is empty.
5 5 Use the left and right arrow
buttons to scroll to the area
you want to modify. All fixtures
in the area will go to maximum
brightness and all other
fixtures will go to minimum
brightness.
Or, use the up and down
arrows and select S S h h o o w w A A r r e e a a
if you know the area number
you want to modify.
Programmer
®
1 1
5 5
-OR-
5 5
6 6
Advertisement
Table of Contents
