Table of Contents
Advertisement
Replacing the Bus Supply
In the unlikely event the EcoSystem bus should fail, a newly installed
bus supply can "learn" the settings of the system by downloading it
from the ballasts. This also clears any existing programming in the
bus supply.
1 1 Make sure the new bus supply
has been properly installed,
but do not perform any
programming steps.
2 2 From the Main Menu, tap
S S y y s s t t e e m m then R R e e p p l l a a c c e e B B u u s s
S S u u p p p p l l y y .
3 3 Read the instructions. Point
the programmer at any IR
control device, then tap
continue.
4 4 Read the caution, then tap
to begin the replacement
procedure.
5 5 If all ballasts flash and go to
their high level, tap
6 6 Once all ballasts go to their
minimum level and then flash,
tap
.
to
.
Programming Guide
57
2 2
Advertisement
Table of Contents
