Ingenico iCT250 Merchant Manual page 40

"M" E r r o r c o d e s
Maximum # of Entries Reached
Memory Almost Full
Do End Of Day Soon
"N" E r r o r c o d e s
No Answer
Press CANC key And Try Again
No Dial Tone
Press CANC Key
And Try Again
No Carrier
Press CANC key
And Try Again
No Last Receipt
Available
No Match
No Response From
Host
Press CANC key
And Try Again
No Receipt Available
Press OK/Cancel
No Transactions Found
Not Accepted
Not Accepted
Use Mag Stripe
Not Accepted Obtain Card
Not Accepted Remove Card
Not Allowed
Not Allowed Until
EOD Completed &
No Trans Outstanding
Not Allowed To
Reset Invoice #
With Open Batch
E x pla n at io n
The maximum number of User IDs
(100) has been reached.
The terminal is close to the limit of
transaction volume allowed for the
current day.
This warning is only displayed at the
end of a financial transaction.
E x pla n at io n
The call was unanswered.
The phone line currently doesn't have
dial tone.
The phone line is currently being used
by others.
If there is no last receipt (duplicate
receipt) available for reprint.
A match cannot be found for the data
entered or selected.
Terminal times out the host response.
Printer failure was detected when the
transaction started.
A transaction cannot be found with the
criteria entered.
The card type entered is not
supported on this terminal.
The card was inserted, but the PINpad
does not have the card type defined
for chip.
Card not accepted.
The card was not accepted.
The transaction selected is not setup
for this terminal or it is not allowed
with the card being used.
The TMS download cannot be
performed if there are outstanding
transactions and until an end of day is
performed and before any new
transaction is performed.
You cannot reset the invoice number
to 1 while there are open batches.
- 34 -
Ac t io n r e q uir e d
To enter additional IDs, some IDs will
have to be deleted.
Perform an end of day.
Ac t io n r e q uir e d
Press Cancel and try again.
Press Cancel and try again.
Press Cancel and try again.
There is not receipt to print as of yet.
Retry or enter new data.
Press Cancel and try again. If the
problem persists contact the TD
Merchant Solutions Help Desk.
Press OK or Cancel and verify printer.
Enter new data.
Request a different card.
Swipe the card on the PINpad.
If the card type is supposed to be
setup for chip, please contact the TD
Merchant Solutions Help Desk.
Request a different card.
Request a different card.
Try another card type.
Perform end of day.
Close all open batches and then reset
the invoice number.