Festo CPX Electronic Manual page 54

2. Fitting
1
Tie rods
2
Loosened module
Fig. 2/3: Removing a module or manifold sub−base
2−10
7. Carefully remove the loosened module by lifting it
upwards.
In order to insert a module or manifold sub−base again,
proceed as follows:
1. Insert the module in the desired position (see Fig. 2/3).
The tie rod must lie exactly over the tie rod groove.
Caution
When sub−bases are arranged in series:
Make sure that the electric plug connectors of the manifold
sub−bases are not bent.
2. Align the CPX terminal on a flat surface so that the compo
nents are not offset.
In the case of CPX terminals without pneumatics or with
CPA pneumatics, you can place the CPX terminal so that
the electrical connections for the system supply and, if
applicable, for the additional supply point upwards. The
tie rod is held in the tie rod groove by the weight force.
A
1 2
Festo P.BE−CPX−SYS−EN en 0503b