Festo CPX Electronic Manual page 53

2. Fitting
1
Tie rod screw
2
Hexagon socket
wrench size 3
Fig. 2/2: Dismantling electric I/O modules
Festo P.BE−CPX−SYS−EN en 0503b
1
2
Caution
Make sure that the electric plug connectors of the manifold
sub−bases are not bent.
3. Loosen the electrical plug connectors on the relevant
manifold sub−base by taking the manifold sub−base apart
carefully and without tilting it.
4. Now push the modules to the left of the module to be
replaced approx. 3 cm to the left.
5. Now push the module to be replaced approx. 1.5 cm to
the left.
6. Make sure that the tie rod lies over the tie rod groove of
the module to be replaced by shifting the module accord
ingly (see arrow A in Fig. 2/3).
1
2−9