Festo CPX Electronic Manual page 183

B. Parameters and data of the CPX terminal
System data: Idle mode
Function no. 1
Description Specifies whether Idle mode is active or inactive.
Bit Bits 2, 3
Values Idle mode
Bit 3 2 Description
0 0 Reset all outputs
0 1 Hold last state (retain signal status)
1 1 Assume Idle mode
Tab. B/53: Idle mode
System data: Monitoring the CPX terminal
Function no. 2
Description Specifies whether the monitoring of short circuit/overload and undervoltage is
active or inactive.
Monitoring
Bit Description
0 Short circuit/overload in sensor supply
1 Short circuit/overload at the outputs
2 Undervoltage outputs (V
3 Undervoltage at valves (V
Short circuit at the valve
4
5 Reserved
6 Reserved
7 Reserved
Values 1 = Active
0 = Inactive
Note See system parameter Diagnostic monitoring".
Tab. B/54: Monitoring the CPX terminal
Festo P.BE−CPX−SYS−EN en 0503b
)
OUT
)
VAL
[Idle mode]
[Reset outputs]
[Hold last state]
[Assume idle mode]
[Monitor]
[Monitor SCS]
[Monitor SCO]
[Monitor Vout]
[Monitor Vval]
[Monitor SCV]
B−41