Function Setting; Dip Switch; Beam Power Control Selector - Optex Smart Line Series Installation Instructions Manual

3

FUNCTION SETTING

3-1 DIP SWITCH

<Transmitter>
4 Channel beam frequency selector switch
Alarm input switch [Positive/Negative]
ON
1 2 3
<Receiver>
4 Channel beam frequency selector switch
Interruption time switch [50/100/250/500ms]
Alarm memory switch [Auto/Manual]
Alarm memory switch [Positive/Negative]
D.Q. (environmental disqualification)/Low battery
output switch [D.Q./Low battery]
ON
1 2 3 4 5 6 7

3-2 BEAM POWER CONTROL SELECTOR

The beam power control selector can be used to avoid unwanted crosstalk that can occur when using multiple photo beams for long
distance or beam stacking applications.
The selector allows you to manually adjust beam power from NORMAL to LOW or VERY LOW.
Make sure the selector select to reduce beam power when using the detector for a distance shorter than the rated distance.
This function is also effective for the following purpose.
For countermeasure against crosstalk due to reflection of walls or ground.
For making optical alignment to support peak adjustment when the monitor jack output beams saturated.
< SL-QDM>
Transmitter
NORMAL VERY LOW NORMAL
LOW
Receiver
NORMAL VERY LOW
LOW
SL-200 QDM/QDP
NORMAL 60 - 30 m
LOW 30 - 15 m
VERY LOW Within 15 m (Within 50 ft)
SL-350 QDM/QDP
NORMAL 100 - 50 m (350 - 175 ft)
LOW 50 - 25 m
VERY LOW Within 25 m (Within 88 ft)
SL-650 QDM/QDP
NORMAL 200 - 100 m (650 - 350 ft)
LOW 100 - 50 m (350 - 175 ft)
VERY LOW Within 50 m (Within 175 ft)
Note>>
Make sure the receiver and transmitter that are facing each other are set to the same position (SL-QDM only).
Caution
SL-QDM
< SL-QDP>
< Illustration >
Transmitter
VERY LOW
LOW
0 m 15 m
(50 ft)
(200 - 100 ft)
(100 - 50 ft)
0 m 25 m
(88 ft)
(175 - 88 ft)
0 m
Be sure to set the beam power control selector according to the installation distance.
Not doing so may result in interference with other sets of detectors.
<Transmitter>
ON
1 2
<Receiver>
ON
1 2 3 4 5 6
VERY LOW
LOW
30 m 60 m
(100 ft) (200 ft)
50 m 100 m
(175 ft) (350 ft)
50 m 100 m
(175 ft) (350 ft)
-10-
SL-QDP
4 Channel beam frequency selector switch
4 Channel beam frequency selector switch
Interruption time switch [50/100/250/500ms]
Alarm memory switch [Auto/Manual]
Alarm memory switch [Positive/Negative]
NORMAL
SL-QDM
SL-QDP
200 m
(650 ft)