Optex Smart Line Series Installation Instructions Manual page 12

d) Perimeter protection
Transmitter 1
Receiver 1
Receiver 3
Transmitter 3
Warning
2 BEAM INTERRUPTION ADJUSTMENT
Initial setting is at 50 msec for normal work. According to the speed of a supposed target you select one specific setting out of 4 steps.
Set the beam interruption adjustment switches of the receiver according to the speed of the human object to detect.
Note>>
The detector operates at 100 msec regardless of the switch position during optical alignment.
3
RE-TRANSMISSION FUNCTION
By connecting a alarm output of other detector to the transmitter. While the alarm input terminal (5) (6) of the transmitter receive the signal
from other detectors, the beam is forced to stop and the receiver sends the alarm signal to the control panel.
< Wiring example >
*2
POWER
UL Listed Outdoor
Motion Detector
(Dry contact only)
Connected a motion
sensor to the alarm
input was not
evaluated by UL/c-UL
< Dip switch >
Transmitter
ON
1 2 3
Note>>
Switches Positive/Negative according to the connected device.
Transmitter 3
Receiver 3
Receiver 1
Transmitter 1
Do not attempt to install this product with any other photoelectric detector.
It may cause the detector to fail or not respond to movements.
ON
Dip switch
(Receiver)
1 2 3 4 5 6 7
Running
(50 msec)
Typical
interruption
time setting
(1)
(2)
(5)
(6)
Dip switch 3: Alarm input
POSITION
ON
ON
OFF
OFF
e) Perimeter protection in a two-stack configuration
Receiver 1
Receiver 2
Receiver 3
Receiver 4
ON ON
1 2 3 4 5 6 7 1 2 3 4 5 6 7
Jogging Walking
(100 msec) (250 msec)
Transmitter
*1 CONTROL PANEL = UL/c-UL listed burglar alarm control panel
*2 POWER = power limited output
-12-
Transmitter 1 Transmitter 2
Transmitter 4
Transmitter 3
Transmitter 2 Transmitter 1
Transmitter 4 Transmitter 3
ON
1 2 3 4 5 6 7
Slow movement
(500 msec)
CONTROL PANEL
(1)
(2)
(8)
(9)
Receiver
MODE
Positive (N.C.)
Negative (N.O.)
Receiver 2
Receiver 1
Receiver 4
Receiver 3
SL-QDM
SL-QDP
SL-QDM
SL-QDP
*1
*2
POWER
ALARM
N.C.