Installation; Separating; Wiring; Installation 2-1 Separating - Optex Smart Line Series Installation Instructions Manual

2

INSTALLATION

2-1 SEPARATING

1
Remove the cover.
1
Loosen the
cover lock screw.
2 Twist it lightly.
Caution

2-2 WIRING

1
Preparing the cut bush
Cut the wiring grommet required according to the wire diameter. Use the lidded grommet for the wiring hole not to be used.
(I.D. : Internal diameter)
2
Threading the wire
1 Cut off the cut bush according to the cable size.
3 Tighten the cable with the banding band.
Caution
A coin
(Not included)
3
Pull
Do not place the main unit where it allows to incident direct sunlight to its optical lens during
installation. Doing so may cause damage to the product.
2 Pass the cable through the cut bush.
4 Cut the excess portion of the banding band.
Do not exceed the voltage or current rating specified for any of the terminals during
installation, doing so may cause fire or damage to the product.
2
Remove the main unit from the chassis.
1
4
2
1 Turn the optical unit 90 degrees
and loosen the screws (both
sides).
I.D. 10mm (0.39 inch)
I.D. 8mm (0.31 inch)
I.D. 6mm (0.24 inch)
I.D. 4mm (0.16 inch)
I.D. 7mm (0.28 inch)
I.D. 6mm (0.24 inch)
I.D. 4mm (0.16 inch)
-4-
3
6
5
2 Pull the upper part of
main unit, and raise it to
remove.
5
Connect to the terminals
Refer to "TERMINAL" on Page
5 to make connections to the
terminals and refer to "OPTI-
CAL ALIGNMENT" on Page 15
to make alignment for the
maximum level of light
reception.