Wiring Distance Between Power Supply And Detector; Wall Mounting - Optex Smart Line Series Installation Instructions Manual

2-5 WIRING DISTANCE BETWEEN POWER SUPPLY AND DETECTOR

- Ensure that the wiring distance from the power supply is within the range shown in the table below.
- When using two or more units on one wire, the maximum length is obtained by dividing the wire length listed below by the number
of units used.
SL-200QDM /
MODEL
SL-200QDP /
WIRE SIZE 12 VDC
0.33 mm 2
600 m
(AWG22) (2,000 ft.)
0.52 mm 2
900 m
(AWG20)
(3,000 ft.)
2
0.83 mm 1,500 m
(AWG18) (4,900 ft.)
1.31 mm 2 2,500 m
(AWG16) (8,000 ft.)

2-6 WALL MOUNTING

1
Open the wiring guide on the back of the chassis using
pliers as shown.
3
Mount the chassis to the wall.
Side wall
Distance from the side wall:
at least 1m
4×20 self tapping
(with rubber washer)
Note>>
Install the unit vertically at a height where an object can be detected without
fail. In case to be stacked, be careful to cover the detection area totally.
SL-350QDM / SL-650QDM
SL-350QDP / SL-650QDP
24 VDC
2,100 m
(7,000 ft.)
3,300 m
(10,000 ft.)
5,300 m
(17,000 ft.)
8,300 m
(27,000 ft.)
<After the cutting>
[ Upper ] [ Lower ]
If two detectors
are installed, the
distance between
the upper and
lower detector
should be at least
20 mm.
Pitch: 83.5 mm
For connection
to gang electric
box
Note>>
UL/c-UL requires to be connected to a UL/c-UL
Listed burglar alarm power limited power supply of
providing a nominal input of 12 VDC (10.5 to 30
VDC) 30 mA (SL-200/350/650 QDM) or 22 mA
(SL-200/350/650 QDP), and battery standby time of
4 hours.
Wiring method shall be in accordance with the
National Electrical Code (ANSI / NFPA 70),
Canadian Electrical Code, Part 1 (CSA C22.1)
Safety Standard for Electrical Installations, local
codes, and the authorities having jurisdiction.
2
Pull the waterproof packing (x2) marked as "①" at the
center of the chassis.
4
Put the waterproof packing back in place.
-6-