Wgen<W>:Output - Keysight Technologies InfiniiVision 4000 X Series Programmer's Manual

37
:WGEN<w> Commands
:WGEN<w>:OUTPut
(see page 1610)
Command Syntax
:WGEN<w>:OUTPut <on_off>
<w> ::= 1 to (# WaveGen outputs) in NR1 format
<on_off> ::= {{1 | ON} | {0 | OFF}
The :WGEN<w>:OUTPut command specifies whether the waveform generator
signal output is ON (1) or OFF (0).
Query Syntax
:WGEN<w>:OUTPut?
The :WGEN<w>:OUTPut? query returns the current state of the waveform
generator output setting.
Return Format
<on_off><NL>
<on_off> ::= {1 | 0}
See Also • "Introduction to :WGEN<w> Commands" on page 1435
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 1465