Mitre Cutting - Erbauer EMIS216S Original Instructions Manual

Take the cutting slit into consideration when cutting along marked cutting
lines. Do not cut directly on the line but next to it.
6. Pull the operating handle (1) forwards until the centre of the saw blade (34) is
directly over the front edge of the workpiece.
WARNING! Turn the lower retractable blade guard (32) by hand to test if
WARNING! Always ensure the saw blade does not interfere with the
fence or any other parts. Remove the fence if necessary.
7.
reach maximum speed.
8. Lower the saw blade to the workpiece slowly.
9. Push the operating handle rearwards to its full extent to cut through the width of
the workpiece.
10. Only apply proper feeding force. Higher feeding force will not increase but lower
the performance of the product, overheat the blade tips and leads to low cutting
surface/edge quality.
11. Switch the product off and allow the saw blade to come to a complete stop before
lifting it from the workpiece.
02

Mitre cutting

Mitre cutting is the same as slide cutting, except that the mitre angle is set to an angle
other than 0°.
1. Adjust the turntable to the desired mitre angle. Make sure the turntable locking
2. Follow the same instruction of "Operation – Slide cutting".
EN
29