Recycling And Disposal - Erbauer EMIS216S Original Instructions Manual

EN
Problem
3. Product does not
cut
4. Unsatisfactory
result
5. Excessive
vibration or noise

Recycling and disposal

Waste electrical products should not be disposed of with household
waste. Please recycle where facilities exist. Check with your local
authority or local store for recycling advice.
34
Possible cause
3.1. Not connected to power
supply
3.2. Saw blade is worn or
damaged
3.3. Bevel and mitre angle
incorrectly adjusted
4.1. Dull / damaged saw
blade
4.2. Cutting angle is incorrect
4.3. Saw blade not suitable
for work piece material
4.4. Overheated saw blade
4.5. Workpiece not clamped /
placed properly
5.1. Saw blade is dull/
damaged
5.2. Bolts/nuts are loose
Solution
3.1. Connect to power supply
3.2. Replace with new one
3.3. Check and adjust
according to the
instruction manual
4.1. Replace with new one
4.2. Adjust the bevel and / or
mitre cutting angle
4.3. Use proper saw blade
4.4. Let the work cool down
before using again
4.5. Clamp / place the
workpiece properly before
cutting
5.1. Replace with a new one
5.2. Tighten bolts/nuts