Storage; Troubleshooting - Erbauer EMIS216S Original Instructions Manual

Storage

1. Switch the product off and disconnect it from the power supply.
2. Clean the product as described above.
3. Slide the cutting head fully forwards and tighten the slide locking knob (8) if
necessary.
4. Follow the reverse order of "Assembly – Operation position" to set the product at
locking position.
5. Store the product and its accessories in a dark, dry, frost-free, well-ventilated
place.
6. Always store the product in a place that is inaccessible to children. The ideal
storage temperature is between 10 °C and 30 °C.
7. We recommend using the original package for storage or covering the product with
a suitable cloth or enclosure to protect it against dust.

Troubleshooting

Therefore check the product using this section. In most cases the problem can be
solved quickly.
WARNING! Only perform the steps described within these instructions!
All further inspection, maintenance and repair work must be performed
cannot solve the problem yourself!
Problem
1. Product does not
start
2. Product does not
reach full power
Possible cause
1.1. Not connected to power
supply
1.2. Power cord or plug is
defective
1.3. Other electrical defect to
the product
2.1. Extension cord not
suitable for operation
with this product
2.2. Power source (e.g.
generator) has too low
voltage
2.3. Air vents are blocked
Solution
1.1. Connect to power supply
1.2. Check by a specialist
electrician
1.3. Check by a specialist
electrician
2.1. Use a proper extension
cord
2.2. Connect to another power
source
2.3. Clean the air vents
EN
33