Controls; Adjusting Mitre Angle; Adjusting Bevel Angle - Erbauer EMIS216S Original Instructions Manual

Controls

WARNING! Always switch the product off and disconnect it from power
supply before making any adjustments!
01
Adjusting mitre angle (Fig. J, K)
1. Unlock the turntable locking handle (20) (Fig. J step 1).
2. Press the mitre angle adjustment lever (21) downward and hold it in positon.
(Fig. J step 2).
3. Hold the turntable locking handle (20) and rotate the turntable (23) until the mitre
angle pointer (16a) aligns with the desired angle on the mitre scale (16) (Fig. J
step 3). Release the mitre angle adjustment lever (21).
4. Press down to lock the turntable locking handle (20) (Fig. J step 4).
There are default adjustment positions for the mitre angle at 0°, ±15°,
±22.5°, ±31.6° and ±45°.
The mitre angle adjustment lever (21) can be locked at pressed position for
convenience.
1. Press the mitre angle adjustment lever (21) downward and hold it in position (Fig.
K step 1).
2. Push the mitre angle adjustment lever locking knob (18) left to lock the lever (Fig.
K step 2).
3. Press the mitre angle adjustment lever (21) downward again to release the locking
knob (18) (Fig. K step 3).
02
Adjusting bevel angle (Fig. L)
1. Unlock the bevel angle locking lever (22) (Fig. L step 1).
2. Pull out the bevel angle locking knob (40) to enable the right bevel angle/ bevel
angle > 45° if required (Fig. L step 2). Move the operating handle (1) a little before
pulling out the bevel angle locking knob if necessary.
EN
25