Additional Safety Warnings For Mitre Saw - Erbauer EMIS216S Original Instructions Manual

EN
o)
such as rods or tubing. Rods have a tendency to roll while being cut, causing the
blade to "bite" and pull the work with your hand into the blade.
p) Let the blade reach full speed before contacting the workpiece. This will
reduce the risk of the workpiece being thrown.
q) If the workpiece or blade becomes jammed, turn the mitre saw off. Wait for all
moving parts to stop and disconnect the plug from the power source and/or
remove the battery pack. Then work to free the jammed material. Continued
sawing with a jammed workpiece could cause loss of control or damage to the
mitre saw.
r)
for the blade to stop before removing the cut-off piece. Reaching with your
hand near the coasting blade is dangerous.
s)
switch before the saw head is completely in the down position. The braking
action of the saw may cause the saw head to be suddenly pulled downward,
causing a risk of injury.

ADDITIONAL SAFETY WARNINGS FOR MITRE SAW

a) Use only saw blades recommended by the manufacturer for wood and analogous
materials.
b) Pay attention to the cutting capacities mentioned in the technical date.
c) Pay attention to the maximum bevel angle and mitre angle settings mentioned in
the technical data.
d) Use only a saw blade diameter in accordance with the markings on the saw and
information about the bore diameter and the maximum kerf of the saw blade.
e) Use only saw blades that are marked with a speed equal or higher than the speed
marked on the tool.
During blade changing procedure, the rotation direction arrow on the saw blade
f)
g) Pay attention to the setting device(s) and the locking device(s) for the mitre angle
and bevel angel mentioned in the controls.
h) Turn the lower retractable blade guard by hand to test if it is rotating smoothly.
Pay attention to how to connect dust extraction systems mentioned in assembly.
i)
Pay attention to the cutting sequence mentioned in the operation.
j)
k) Pay attention to the cutting depth for non-through cuts mentioned in the controls.
Ensure that the mitre saw is always stable and secure.
l)
m)
n) Use additional supports if needed to ensure the stability of the workpiece.
o) The power tool shall not be wet or applied in wet environment.
p) Check the product, its power cord and plug as well as accessories for damage
before each use. Do not use the product if it is damaged or shows wear.
q)
r) Always hold the product on its handle. Keep the handle dry to ensure safe support.
12