Operating Position; Workpiece Clamp; Fence - Erbauer EMIS216S Original Instructions Manual

WARNING! The product must be fully assembled before operation!
Do not use a product that is only partly assembled or assembled with
damaged parts!
Wear protective gloves for this assembly work and always lay the product
Follow the assembly instructions step-by-step and use the pictures
provided as a visual guide to easily assemble the product!
Do not connect the product to power supply before it is completely
assembled!
WARNING! The product and the packaging are not children's toys!
Children must not play with plastic bags, sheets and small parts! There is
a danger of choking and suffocation!
02
Operating position (Fig. A)
1. Push the operating handle (1) (step 1) downwards and disengage the locking bolt
(24) from its locking position (step 2).
2. Lift the operating handle (1) to its full height (step 3).
03
Workpiece clamp (Fig. B)
The workpiece clamp (11) is pre-assembled. Insert the height adjustment pillar (11b)
into the workpiece clamp holder (38) on either side of the base if necessary.
04
Fence (Fig. C)
Install:
1. Unlock the fence locking lever (37) (step 1).
2. Align the fence gaps (13a) with the screws (37a). Insert the fence (13) into the slot
(step 2).
3. Slide the fence to the desired position (step 3).
EN
21