Table of Contents
Advertisement
EN
3. Move the operating handle (1) until the bevel angle pointer (10a) aligns with the
desired angle on the bevel scale (10) (Fig. L step 3).
WARNING! Always ensure the saw blade does not interfere with the
fence or any other parts. Remove the fence if necessary.
4. Lock the bevel angle locking lever (Fig. L step 4).
WARNING! Always check the bevel locking handle (22) before working. A
loose bevel locking handle may cause serious injury.
03
Adjusting cutting depth gauge (Fig. M)
Use the depth stop (35a) and adjustment knob (35c) to limit the cutting depth of the
saw blade into the workpiece.
1. Push in the depth stop (35a) to cut the workpiece with the max. cutting depth.
2. Pull out the depth stop (35a) (step 1).
3. Loosen the locking nut (35b) (step 2).
4. Turn the adjustment knob (35c) clockwise to decrease the cutting depth (e. g. for
non-through cutting operations such as grooving / slotting) (step 3).
5. Turn the adjustment knob (35c) anticlockwise to increase the cutting depth.
6. Tighten the locking nut (35b) (step 4).
04
Adjusting slide cutting (Fig. N)
1. Use slide cutting to saw a workpiece that is larger than the maximum cutting length
of the saw blade.
2. Loosen the slide locking knob (8) (step 1) to allow the cutting head to slide freely
(step 2).
05
Adjusting extension supporter (Fig. O)
Use the extension supporter for supporting long workpieces. Use an additional support
for extremely long workpieces if required.
1. Unlock the extension supporter locking lever (15) (step 1).
2. Pull out the extension supporter (14) to desired position (step 2).
3. Pull out the small fence (14a) if necessary (step 3).
4. Lock the extension supporter locking lever (15) (step 4).
26
Hide quick links:
Advertisement
Table of Contents
