Table of Contents
Advertisement
EN
09
Laser (Fig. R, S)
Use the laser as guide when cutting.
1. Switch the laser (31) on by pressing the "laser" symbol of the laser switch (3).
2. Switch the laser off by pressing the "OFF" of the laser switch.
The laser line should be aligned with the blade cutting path. Readjustment of the laser
shall always be carried out by the manufacturer of the tool or his service organization.
10
Switching on/off (Fig. R)
1. Press either the left safety lock button (29) or the right safety lock button (27) down
to unlock the on/off switch (28) (step 1).
2. Press the on/off switch (28) to switch the product on (step 2).
3. Release the on / off switch (28) to switch the product off.
Operation
WARNING! Check the voltage before plug in. The voltage must comply
with the information on the rating label!
01
Slide cutting
Use slide cutting to saw a workpiece that is larger than the maximum cutting length of
the saw blade. Use slide cutting in mitre, bevel or compound angle adjustment.
1. Set the product at "operation position".
2. Loosen the slide locking knob (8) to allow the cutting head to slide freely.
3. Adjust the cutting depth gauge (35) to desired cutting depth if required.
4.
Place the convex edge of the workpiece against the fence if it is warped.
The workpiece could break and jam the saw blade if the concave edge is
placed against the fence.
5.
28
Hide quick links:
Advertisement
Table of Contents
