Safety Instructions For Laser; Additional Safety Warnings For Construction Dust - Erbauer EMIS216S Original Instructions Manual

s) Ensure that the air vents are always unobstructed and clear. Clean them if
necessary with a soft brush. Blocked air vents may lead to overheating and
damage the product.
Switch the product off immediately if you are disturbed while working by other
t)
people entering the working area. Always let the product come to complete stop
before putting it down.
u) Do not overwork yourself. Take regular breaks to ensure you can concentrate on
the work and have full control over the product.

SAFETY INSTRUCTIONS FOR LASER

a) Do not stare directly at the laser beam. A hazard may exist if you deliberately stare
into the beam.
b) The laser shall be used and maintained in accordance with the manufacturer's
instructions.
c) Never aim the beam at any person or an object other than the work piece.
d) The laser beam shall not be deliberately aimed at another person and shall be
prevented from being directed towards the eye of a person for longer than 0.25
seconds.
e)
may direct the laser beam back at the operator.
Do not change the laser device with a different type. Repairs must be carried out
f)
by the manufacturer or an authorized agent.
g) CAUTION:
result in hazardous radiation exposure.
The following information applies to professional users only but is good practice for all
users:

ADDITIONAL SAFETY WARNINGS FOR CONSTRUCTION DUST

The updated Control of Substances Hazardous to Health Regulations 1st October
2012 now also targets to reduce the risks associated with silica, wood and gypsum
dusts.
Construction workers are one of the at-risk groups within this because of the dust that
they breathe: silica dust is not just a nuisance; it is a real risk to your lungs!
Silica is a natural mineral present in large amounts in things like sand, sandstone and
granite. It is also commonly found in many construction materials such as concrete and
Silica or RCS) during many common tasks such as cutting, drilling and grinding.
Laser radiation
Do not stare into beam
Class 2 laser product
EN 60825-1:2014
P < 1mW, λ = 650nm
EN
13