Table of Contents
Advertisement
EN
03
Bevel cutting
Bevel cutting is the same as slide cutting, except that the saw blade bevel angle is set
to an angle other than 0°.
1. Adjust the saw blade to the desired bevel angle. Make sure the bevel angle locking
2. Follow the same instruction of "Operation – Slide cutting".
04
Compound bevel mitre cutting
This sawing operation combines a mitre angle with a bevel angle.
1. Adjust the turntable to the desired mitre angle. Make sure the turntable locking
2. Adjust the saw blade to the desired bevel angle. Make sure the bevel angle locking
3. Follow the same instruction of "Operation – Slide cutting".
After use
1. Switch the product off, wait for complete stop, disconnect it from the power supply
and let it cool down.
2. Check, clean and store the product as described below.
WARNING! Always switch the product off, disconnect the product from
the power supply and let the product cool down before performing
inspection, maintenance and cleaning work!
Only perform care and maintenance work according to these instructions!
30
Care & maintenance
Hide quick links:
Advertisement
Table of Contents
