Adjusting Fence; Adjusting Workpiece Clamp; Led Light - Erbauer EMIS216S Original Instructions Manual

06
Adjusting fence (Fig. P)
1. Unlock the fence locking lever (37) (step 1).
2. Slide the fence (13) to desired position (step 2).
3. Lock the fence locking lever (37) (step 3).
Ensure the saw blade does not interfere with the fence by conducting a
"dry run" with the cutting head set to the required bevel and mitre angle.
07
Adjusting workpiece clamp (Fig. Q)
The workpiece clamp (11) can be assembled on either side of the base. Use it to
support workpieces of different thickness by adjusting the height of the bracket (11d)
and plate (11c).
Ensure the motor housing does not interfere with the clamp while
operation with the cutting head set to the required bevel and mitre angle.
1. Loosen the locking knob (11a) (step 1) on the height adjustment pillar (11b) and
adjust the bracket (11d) to the desired height (step 2). Tighten the locking knob to
secure the bracket (step 3).
2. Press the locking button (11e) and hold it in position (step 4). Adjust the height of
the plate (11c) to the surface of the workpiece (step 5).
3. Rotate the height adjustment knob (11f) clockwise tightly to secure the workpiece
before operation (step 6).
Add a small scrap piece of thin plywood under the workpiece clamp to
avoid marking the workpiece.
08
LED light (Fig. R, S)
1. Switch the LED light (25) on by pressing the "light" symbol of the LED light switch
(2).
2. Switch the LED light off by pressing the "OFF" of the LED light switch.
EN
27