Bench Mounting; Dust Extraction - Erbauer EMIS216S Original Instructions Manual

7.
screw (34a). Tighten the clamping screw anti-clockwise with the provided multi tool
while the spindle locking button (26) is pressed.
8.
9. Push the lower retractable blade guard to slide the guard mounting plate (33)
downward and tighten the locking screw (33a) with the provided multi tool.
10. Close the lower retractable blade guard (32) afterwards.
06

Bench mounting

There are 4 mounting holes (12) at each corner of the base (39) to facilitate bench
mounting.
1. Place the mitre saw over the workbench tabletop and mark four locations on top of
the workbench that correspond to the mounting hole positions.
2. Drill four mounting holes (Ø11 mm) at the marked location of the workbench.
3. Place the mitre saw on the workbench and align the mounting holes of the base
with the drilled holes in the workbench.
4. Firmly secure the mitre saw to the bench surface with 4 bolts (not provided).
WARNING! For stability, turn the support bolt (19) clockwise to make
sure it contacts with the bench surface.
5. Carefully check the workbench after mounting to make sure that no movement can
occur during use. If any tipping, sliding, or other movement is noted, secure the
07
Dust extraction (Fig. G, H, I)
WARNING! Always attach a dust extraction device when using this
product to keep the working area clean!
Wear a dust mask when operating this product! Dust can be harmful to
health!
EN
23