Precautions Before Operation; 2-1.Unpacking The Instrument; 2-2.Checking The Line Voltage - GW Instek LCR-800 Series User Manual

LCR-800 Series User Manual

2. PRECAUTIONS BEFORE OPERATION

2-1. Unpacking the instrument
The product has been fully inspected and tested before shipping from the
factory. Upon receiving the instrument, please unpack and inspect it to
check if there are any damages caused during transportation. If any damage
is found, notify the bearer and/or the dealer immediately.
2-2. Checking the Line Voltage
The LCR Meters can be operated with AC power source between 100V
rated voltage and 240V rated voltage at a frequency of 50 to 60Hz, no AC
voltage selector is necessary. Power connection to rear panel is through an
AC inlet module comprised of an AC connector and fuse holder. To change
the fuse proceed as follows:
Remove the fuse holder by inserting a small flat head screwdriver
!
behind the small tab to force the holder outward.
Install the correct fuse (slow-blow, 3A, 250Vac).
!
Re-install the fuse holder back into the LCR Meters AC inlet module,
!
push in and lock.
WARNING. To avoid electrical shock the power cord protective
grounding conductor must be connected to ground.
WARNING. To avoid personal injury, disconnect the power cord
before removing the fuse holder.
2