Related Manuals for GW Instek LCR-8200 Series
Summary of Contents for GW Instek LCR-8200 Series
- Page 1 LCR Meter LCR-8230/8220/8210/8205 FIRMWARE UPDATE MANUAL VERSION: 1.00 ISO-9001 CERTIFIED MANUFACTURER...
- Page 2 This manual contains proprietary information, which is protected by copyrights. All rights are reserved. No part of this manual may be photocopied, reproduced or translated to another language without prior written consent of Good Will company. The information in this manual was correct at the time of printing. However, Good Will continues to improve products and reserves the right to change specifications, equipment, and maintenance procedures at any time without notice.
- Page 3 Table of Contents Table of Contents INTRODUCTION ............4 Requirements ............. 4 FIRMWARE UPDATE PROCEDURE ........ 5 Flashing the Microcontroller ........5...
- Page 4 The LCR-8200 Series LCR Meters have upgradable firmware to ensure your purchase has a long and useful life with updates and improvements. There are four models in the LCR-8200 Series, all of which can be updated by using the same common firmware file.
- Page 5 FIRMWARE UPDATE PROCEDURE IRMWARE UPDATE PROCEDURE Flashing the Microcontroller 1. A USB flash drive will be needed for the update 1. USB Disk procedure. 2. Copy the new firmware file〝LCR8200.BIN〞to the :\LCR8200\BIN of the USB flash drive. If this path is not available, create it first. 3.
- Page 6 LCR-8200 Series Firmware Update Manual 5. Plug the USB drive that has the new firmware file 3. Plug in the USB into the front panel USB port on the LCR-8200. drive 6. The meter will show information of the USB drive.
- Page 7 FIRMWARE UPDATE PROCEDURE 9. When being rebooted, the meter will show the 5. Update updated firmware version on its display for confirmation confirmation. 10. Alternatively, you can confirm whether the updated firmware version is correct by checking S/W Ver at SYSTEM CONFIG page.