Firmware And Drivers - Konica Minolta bizhub C3110 Service Launch Manual

Program Release Information
CSES ID-No. DLBT1404696EN00
Model: bizhub C3110
Title: Initial Mass-production Program (Controller Firmware)
1. Release version and download file name
The newly released program version and download file name are as follows.
[Release Version]
Model Program Name
bizhub
Controller firmware
C3110
[Download file name]
bizhubC3110_Cont_A6DT30G0116-999.zip
PRI_DLBT1404696EN_0.doc
2. Changes
This is the initial version.
3. Restrictions
<Planned to be supported in MR of around the middle of Nov,2014.>
- When the machine wakes up from Deep Sleep mode with a USB flash memory connected to it, sometimes "USB CONN
ERR" is displayed and printing cannot be done.(This does not occur if a USB flash memory is connected during Deep
Sleep mode. It occurs when the machine enters Deep Sleep mode with a USB flash memory connected and wakes up
later.)
- If you specify 2W or below as power consumption for Deep Sleep mode (development goal), sometimes the machine
does not wake up.
(Remove the function that sets the power consumption to 2W or below.)
- When there is no HDD installed, if canceling a copy job during Memory Full caused by paper empty or something, the job
status will be shown as "Printing" in PSWC although the true status is "Being cancelled".
- During a fax transmission, if you start a copy job and press Stop or Reset key while scanning the copy document, you
will see "Please wait..." on the operation panel. If the fax job has been completed before the message "Are you sure to
cancel the job?" appears, the "Please wait..." message will be kept displayed.
<The following item remains unsupported this time.>
- When the part life of the second transfer roller, transfer belt, or the fixer reaches 256K pages, their life information will be
cleared. (Therefore it appears to be as if there is still remaining life.)
(Based on the product specification, 100K is the normal life value. This phenomenon occurs because 256K exceeds the
normal life value.)
4. Programs to be applied at the same time
There is no specific program to be applied with this firmware.
However, using with the latest version programs is recommended.
5. How to install
Please refer to "J. Rewriting of firmware ", Service Manual.
* Company names and product names in this document are the registered trademarks for respective companies.
Copyright(C) 2014 KONICA MINOLTA, INC.
12
Current Ver. New Ver.
A6DT30G0116-
-
999
1/1
Download file name
8bd521b569f21b82e59aa
bizhubC3110_Cont_A6
87a94c87bc9aebaca8998
DT30G0116-999.zip
6dea4f7335e084ebcecf1b
2014/4/15
SHA-256