Honeywell ADEMCO VISTA-120 Installation And Setup Manual page 79

Time-Driven Event Programming
The following menu items must first be programmed in
Output Programming in the #93 Menu Mode:
Enter Relay No. (reference identification number)
Output Group (if applicable)
Restriction
Output Type (V-Plex, 4204/4204CF, FSA or X-10)
Zone No. (V-Plex)
ECP Address (4204/4204CF)
Relay No. (4204/4204CF)
LED No. (FSA)
House Code (X-10)
Unit Code (X-10)
PROMPT
Timed Events ?
1 = YES 0 = NO 0
TIMED EVENT # ?
01-20, 00=Quit 01
01 ACTION ?
none 00
ACTION CODES
01=Relay On
02=Relay Off
03=Relay Close for 2 seconds
04=Relay Close XX minutes
05=Relay Close YY seconds
06=Relay Group On
07=Relay Group Off
08=Relay Group Close for 2
seconds
09=Relay Group Close XX
minutes
10=Relay Group Close YY
seconds
20=Arm-STAY
21=Arm AWAY
22=Disarm
23=Force Arm STAY
24=Force Arm AWAY
25=Arm INSTANT
26=Arm MAXIMUM
40=Enable Open Time Period
by Part.
41=Enable Close Time Period
by Part.
30=Auto bypass – Zone list
31=Auto unbypass – Zone
list
EXPLANATION
Enter 1 to program timed events.
Enter the timed event number to be programmed (01-20).
Press [✳]. The system then prompts the user to enter the desired action to be taken.
Enter 00 at the "TIMED EVENT #?" prompt to quit the timed event menus and display the "Quit ?" prompt.
Enter the action code for this timed-event number from the list at the left. This could be an output command,
an arming command, or any other Time-Driven event.
Press [✳] to accept the entry. The prompt for the action specifier appears.
EXPLANATION
Actions 01-05
If you selected actions 01-05, the prompt at the right appears. Enter the relay
number.
Press [✳] to accept entry. The "Time Window ?" prompt appears.
Actions 06-10
If you selected actions 06-10, the prompt at the right appears. Enter the relay
group number.
Press [✳] to accept entry. The "Time Window ?" prompt appears.
Actions 21-26 and 40-41
If you selected actions 21-26 or 40-41, the prompt at the right appears. Enter
the partition to which the action applies. Enter 0 to select all partitions. Enter
a partition number again to deselect it.
Press [✳] to accept entry. The "Time Window ?" prompt appears.
Actions 30-31
If you selected actions 30-31, the prompt at the right appears. Enter the zone
list number that contains the zones to be bypassed or unbypassed.
Press [✳] to accept entry. The "Time Window ?" prompt appears.
Section 6 - Scheduling Options
After entering Scheduling Menu Mode, press [0] until
the "Timed Events ?" prompt appears.
ACTION SPECIFIER
01 RELAY # ?
00
01 RELAY GRP # ?
00
PART? 12345678
HIT 0-8 X X
01 ZONE LIST ?
ENTER 01-15 01
6-9