Honeywell ADEMCO VISTA-120 Installation And Setup Manual page 16

VISTA-120 Installation and Setup Guide
Multi-Partition Multi-Panel Mode
To perform a function in the Multi-Partition, Multi Panel mode, follow the steps below:
Step Action
1 Enter User Code (for users 001-050) + [#] + [88].
The keypad displays the following:
PANELnn
STATUS
where "nn" = panel ID number (01-08), "12345678" are the partition numbers and "xxxxxxxx" is the status of
each partition of that panel. Status indications include:
A = Armed Away
I = Armed Instant
B = Bypassed/Ready
F = Fire Alarm
C = Comm Fail
NOTES: See table later in this section for priority of displays.
A "•" under a partition number indicates the user does NOT have access to that partition.
2 The following functions can be performed:
Press [1] to attempt to disarm all partitions.
Press [2] to attempt to arm AWAY all partitions.
Press [3] to attempt to arm STAY all partitions.
Press [4] to attempt to arm MAXIMUM all partitions.
Press [7] to attempt to arm INSTANT all partitions.
Press [✴] to read the status of the next panel.
Press [#] key to read the status of the previous panel.
Press [0] to exit mode. After a few seconds, the keypad displays the status of the original partition of the
original panel for the keypad. Also, this mode will end in approximately 120 seconds if no keys are pressed.
NOTES: When performing any of the arming commands, if there are faults in any of the partitions, none of
the partitions will arm. These faults must be corrected or bypassed before attempting to arm.
The user cannot execute another panel linking mode. To execute another panel linking mode or to access a
different remote panel, the user must first exit this mode (return to the original control panel).
2-6
1 2 3 4 5 6 7 8
x x x x x x x x
S = Armed Stay
R = Ready
✴ = Alarm
P = AC Power Failure
M = Armed Maximum
N = Not Ready
T = Trouble
L = Low System Battery