For shaft drive service
Damper spring compressor
(P/N YM-04011)
This tool is needed to disassemble and reassemble
the middle gear damper.
Final drive gear lash tool
(P/N YM-01230)
This tool is needed when measuring gear lash for
final gear.
Ring gear holder
(P/N YM-01254)
This tool is needed when measuring gear lash.
Bearing retainer wrench
(P/N YM-33214)
This tool is used to loosen or tighten the bearing
retainer.
For electrical components
The uses of these tools are described in Chapter 6.
Electro tester
(P/N YU-03021)
Pocket tester
(P/N YU-03112)
13