Water Pump Cover, And Joint Pipes, And Oil Filter; Mounting The Engine - Yamaha XZ550RJ 1982 Service Manual

Hide thumbs Also See for XZ550RJ 1982:
Table of Contents

Advertisement

Water pump cover, joint pipes, and oil filter
1. Install the water pump cover O-ring and in-
stall the 0-rings on the joint pipes.
2. Sparingly apply rubber grease to the joint
pipe 0-rings.
3. Install the joint pipes into the water pump
cover.
NOTE:
The joint pipes should be positioned as shown be-
low:
4. Install the water pump cover and joint pipes
onto the engine at the same time and
torque the bolts to specification.
Tightening torque:
10 Nm (1.0m-kg, 7.2ft-lb)
5. Install the new oil filter element and O-ring.
Tighten the oil filter bolts to specification.
Tightening torque:
10 Nm (1.0m-kg, 7.2ft-lb)
NOTE:
Make sure the O-ring is positioned properly.
1. Oil filter cover
2. O-ring
3. Oil filter element

Mounting the engine

1. Place the engine on a block or other suit-
able engine stand. It is easier if you ap-
proach the engine from the right side.
2. Align the splines of the U-joint with those
of the drive shaft; then move the engine into
place in the frame.
Page 91

Advertisement

Table of Contents
loading

Table of Contents