Applicable Systems - Mitsubishi Melsec-L Series User Manual

(2) 10BASE-T connection
To configure a system for 10BASE-T connection, use devices that meet the IEEE 802.3 10BASE-T standards.
Configuration device
Unshielded twisted
pair cable (UTP) or
shielded twisted pair
*2
cable (STP)
Connector
Hub
*1 This applies when a repeater hub is used. For the number of levels that can be constructed when a switching hub is
used, consult with the manufacturer of the switching hub used.
*2 Data can be communicated with an E71 (between LJ71E71-100 modules). In addition, an E71 can be directly connected
to a GOT.
Remark
Consult a network specialist for required devices.
5.3

Applicable Systems

This section describes MELSEC-L series systems that include an E71.
(1) Applicable CPU modules and the number of connectable modules
An E71 can be connected to an LCPU with an serial number (first five digits) of 14112 or later.
For the number of connectable modules, refer to the following.
MELSEC-L CPU Module User's Manual (Hardware Design, Maintenance and Inspection)
(2) Applicable software
GX Works2 is required for setting and diagnosing an E71. GX Developer cannot be used.
58
Straight cable
A Category 3, 4, or 5 straight cable or cross cable is usable.
Cross cable
RJ45 connector
10Mbps hub
Up to four levels of cascade connection can be configured.
Software
GX Works2
Description
-
Version
1.95Z or later
*1