14.4.3
If the SD/RD LED does not flash when data is sent
The following table lists the items to be checked and the actions to be taken if the SD LED does not flash when data is
sent.
Check item
Is the ERR. LED or COM.ERR. LED on?
Are the cables properly connected?
Are the parameter settings correct?
Is the program correct?
If the action above does not solve the problem, perform the following tests on the E71 to check for hardware error.
• Hardware test (
• Self-loopback test (
192
Remove the cause that turned on the ERR. LED or COM.ERR. LED.
Check the cable connection. In addition, perform a line test to check if there
is a problem with the cable connection and the Ethernet line.
(
Page 256, Appendix 4)
Correct the IP addresses of the own station and the communication
destination, router setting, and subnet mask setting.
Correct the send program of the connected device.
Page 266, Appendix 5.2)
Page 265, Appendix 5.1)
Action