Mitsubishi Melsec-L Series User Manual page 270

(1) Functional comparison
The following table lists the functional comparison.
Function
Initial process with the program
Initial process
Initial process with parameter settings
Open process with the program
*1
Open process
Open process with parameter settings
Procedure Exist
Communications using
a fixed buffer
No Procedure
Communications using a random access buffer
MC protocol communications
Communications using data link instructions
BUFRCVS instruction
Interrupt process (upon
data receiving)
RECVS instruction
Send/receive with the program
E-mail function
Send with the auto notification
function
File transfer (FTP server) function
Web function
Broadcast communications
Communications with the switch on the CPU module set to STOP
Selection of the communication data code (ASCII/binary)
CC-Link IE Controller Network, CC-Link IE Field Network,
MELSECNET/H, MELSECNET/10 relay communications
Router relay function
Ping
Connected device alive
check
KeepAlive
Pairing open
Unit of each timer
500ms
setting value for data
2s
communications
TCP/IP
Connection to
MELSOFT products
UDP/IP
Installation of EEPROM
TCP Maximum Segment Size Option transmission
*1 For the E71, the number of connections for the open process from the CPU module has increased to 16 connections.
*2 Compatible with the I/O signal and QE71(N) buffer memory
*3 Data of up to 960 words can be read from/written to an E71, and up to 480 words in a QE71(N).
*4 Usage depends on the CPU module and programming tool version.
*5 This applies to a module with the software version of Q or earlier.
*6 No EEPROM is installed. Items registered in the EEPROM of a QE71(N) are set using the parameter settings of the
programming tool.
*7 This applies to a module with the software version of E or later.
*8 If the E71 cannot communicate data when combined with a certain connected device, the setting can be changed in the
buffer memory (address: 30(1E
process.
268
AJ71E71-S3,
AJ71E71
AJ71E71N
× ×
× ×
×
× ×
× ×
× ×
× ×
× ×
× ×
× ×
×
×
× ×
×
×
× ×
×
*5
×
(Fixed)
× ×
×
× ×
×
)). ( Page 33, Section 3.5.2) After changing the setting, execute the reinitialization
H
: Supported, ×: Not supported
QE71(N)
9706 or earlier 9706B or later
×
×
×
×
×
×
×
×
×
×
×
×
(Fixed)
×
×
*7
×
E71
×
*2
*2
*3 *3
*4
×
×
×
×
×
*4
×
(Fixed) (Fixed)
× ×
×
*6
×
*7 *8