Silicon Graphics InfiniteStorage 4000 Series System Upgrade Manual page 130

122
NOTE Refer to the storage management software Failover Drivers User Guide for
information about failover driver installation and configuration on the Linux OS. You
must complete manual procedures for correct failover driver installation.
NOTE The storage management software supports the use of the storage array as a
boot device.
Modify these instructions as required for your specific installation.
1. Make sure that you have root privileges, which are required to install the
software.
2. Insert the installation CD into the CD-ROM drive.
3. If necessary, mount the CD-ROM drive. In the example command that follows,
the installation CD is mounted at /mnt.
NOTE This mount point is shown here only as an example. You might need to modify
this command for your operating system. If you need more information about
mounting devices on your operating system, refer to the documentation that came with
your operating system.
mount /dev/hda /mnt
4. At the prompt, type this command, and press Enter. In this command,
SMIA-LINUX.bin is the name of the installation program on the CD.
sh SMIA-LINUX.bin
After the software is loaded, the Introduction window appears.
5. Click Next.
The License Agreement window appears.
6. Select the option that accepts the terms of the License Agreement.
7. Click Next.
The Select Installation Type window appears.