Checking The Installation On The Solaris Os - Silicon Graphics InfiniteStorage 4000 Series System Upgrade Manual

Checking the
Installation on
the Solaris OS
Chapter 5: Upgrade Instructions for the Solaris OS
13. Click Install.
The Installing window appears while the software is loading. When the software
is loaded, the Install Complete window appears.
NOTE If you cancel an installation before the installation completes or
while the progress bar is still visible, the installation stops prematurely.
The software creates an installation log. You must manually uninstall the
software.
If you cancel the installation before the progress bar is visible, you do not
need to uninstall the software.
14. To exit the installation program, click Done.
Several files and program packages are installed to the /opt/SM9 directory and
the /opt/StorageManager directory.
After you have completed installing the software packages, check that they installed
successfully.
1. At the prompt, type this command, and press Enter.
pkginfo -l <package name>
In this command, <package name> is the name of a package that you
installed.
a. To determine which software packages reside on your system, type this
command at the prompt.
pkginfo | grep SM
Look for the storage management software packages, such as SMagent,
SMclient, SMutil, and SMruntime.
b. To determine whether the RDAC driver package resides on your system,
type this command at the prompt. In this command, <rdac> is the RDAC
package name.
pkginfo | grep <rdac>
Look for the storage management softwareRDAC package.
2. From the /opt/StorageManager directory, review any error messages from
the error message log, and correct the problem. If the problem persists, contact
your Technical Support representative.
3. For each package you installed, repeat step 1 through step 2.
115