Checking The Installation On The Hp-Ux Os - Silicon Graphics InfiniteStorage 4000 Series System Upgrade Manual

Checking the
Installation on
the HP-UX OS
108
NOTE If you cancel an installation before the installation completes or
while the progress bar is still visible, the installation stops prematurely.
The software creates an installation log. You must manually uninstall the
software.
If you cancel the installation before the progress bar is visible, you do not
need to uninstall the software.
13. To exit the installation program, click Done.
Several files and program packages are installed to the /opt/SM9 directory and
the /opt/StorageManager directory.
After you have completed installing the software packages, check that they installed
successfully.
1. At the prompt, type this command, and press Enter:
swlist | grep SM*
This command lists the storage management software packages that you
installed.
2. At the prompt, type this command, and press Enter:
swverify -v <package name>
In this command, <package name> is the name of a package that you
installed.
3. Note any failure reported.
4. For each package you installed, repeat step
5. Was the installation successful (no problems were reported)?
Yes – Go to step 6.
—
No – From the /opt/StorageManager directory, review any error
—
messages from the error message log, and correct the problem. If the
problem persists, contact your Technical Support representative.
6. For each system that is used as a storage management station or host, perform the
software installation and removal procedures that are described in this chapter.
2 through step 3.