Accessing Network Through The Iad - Huawei eSpace IAD104H Quick Start Manual

eSpace IAD104H
Quick Start
Verification

4.5 Accessing Network Through the IAD

Issue 10 (2019-04-09)
After the preceding configuration is complete, the IAD is
running properly. You can use the following method to verify
the configuration:

Choose SIP Service Configuration > FXS User. The
FXS configuration page is displayed. View the user
registration status. If the state is Registered, it indicates
that the user is registered successfully.

Make calls to verify the correctness of the configuration.
If calls can be made or received successfully, it indicates
that the data is configured correctly.
If a fault exists, check whether the data is correctly configured.
If the data is correct but the fault persists, see the eSpace IAD
Troubleshooting Guide to locate the fault.
A PC can access the network through the IAD104H.
For example, to configure a PC to access the network through
the IAD104H, do as follows:
Connect the PC to the LAN port of the IAD, and the
1.
WAN port to the uplink, as shown below.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 Manual Configuration (CLI)
38