Connecting To The Ims (Sip) - Huawei eSpace IAD104H Quick Start Manual

eSpace IAD104H
Quick Start
Verification

4.4 Connecting to the IMS (SIP)

Data Plan
Issue 10 (2019-04-09)
After the preceding configuration is complete, the IAD runs
properly. You can verify the configuration results by checking
indicators and voice communication.

Choose MGCP Service Configuration > MG to access
the MG configuration page to view the user registration
status. If the Registered state is displayed, it indicates
that the corresponding phone is registered successfully.

You can verify calls. If calls can be performed or received
successfully, it indicates that the data is configured
correctly.
If a fault occurs, you need to check whether the data is
correctly configured. If the fault persists, see eSpace IAD
Troubleshooting Guide to locate the fault.
The IAD104H can connect to the IMS directly or through
SoftSwitch. If the IAD connects to the IMS through
SoftSwitch, configure the IAD according to the scenario where
the IAD connects to the IP PBX. This topic describes the
scenario where IAD users directly register with the IMS. After
configuring data on the IMS, configure the IAD104H so that
the IAD104H can provide voice services, including basic call
and fax services.
You can obtain the connection data between the IAD and the
IMS from the network carrier or network administrator. The
following describes how to enable the voice function for an
IAD104H user.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 Manual Configuration (CLI)
27