Huawei eSpace IAD104H Quick Start Manual page 26

eSpace IAD104H
Quick Start
Step 4 Configure the MG data.
Issue 10 (2019-04-09)

If the IP address obtaining mode is changed, the IAD restarts
automatically for the configuration to take effect. You can dial
*127 using a phone connected to the IAD and listen to the IP
address played by the phone, or you can connect to the IAD
using a serial cable to check the new IP address.
 If obtaining an IP address in DHCP or PPPoE mode is selected
but the IAD fails to obtain an IP address in this mode, it takes
about 8 minutes for the IAD to restart. In this case, check
whether the DHCP or PPPoE server is available and whether the
server information is correctly configured.
After the IP address is changed, re-log in to the web
management system, click
and click Start to access the Basic Configuration >
Network Parameter page again.
5. (Optional) Configure the DNS server.
If the DNS server is available on the network, you can
configure the DNS server on the IAD so that the IAD can
access other devices by domain name.
a. Set DNS parameters according to the data plan and
help information.
b. Click Save.
1. Click Next.
The MGCP Service Configuration > MG page is
displayed.
2. Set MG parameters.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 Manual Configuration (CLI)
,
24