Huawei eSpace IAD104H Quick Start Manual page 10

eSpace IAD104H
Quick Start
Establishing the Web Configuration Environment
Issue 10 (2019-04-09)

HTTP
The web browser interacts with IAD104H through HTTP.
You are advised to log in to the web management system
through HTTPS to ensure data security.
HTTP is disabled on the IAD by default. You can run the
system soft-parameter command to enable HTTP.
Before logging in to the web management system through
HTTPS, you have to load the web_rootcert, web_servercert,
and web_serverkey certificates and restart the IAD. For
details about how to load the certificates and restart the IAD,
see the load and reboot commands under Command
Reference > Config Commands in the eSpace IAD104H
Product Documentation.
The IAD hardware connections are set up and the IAD is
powered on.
Use the network cable to connect the network port of the PC to
any network port of the IAD104H. If the PC network port does
not support self-adaptation, you need to use the crossover cable.
Set IP addresses of the PC and IAD (the default IP address of
the IAD is 192.168.100.1) in the same network segment to
ensure that the PC can ping the IAD successfully.
Before the delivery, the same IP address 192.168.100.1 is configured
on all IADs. Do not connect multiple IADs to the network at the
same time to prevent IP address conflict.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 Manual Configuration (CLI)
8