Huawei eSpace IAD104H Quick Start Manual page 47

eSpace IAD104H
Quick Start
Issue 10 (2019-04-09)
A: Log in to the CLI, and run the enable and configure
terminal commands in sequence to enter the global
configuration mode. Then run the display elabel
command.
Q: How do I view the software version of the IAD?
11.
A: Log in to the CLI, and run the enable and configure
terminal commands in sequence to enter the global
configuration mode. Then run the display version
command.
Q: How do I change the protocol?
12.
A: To change to the SIP mode, log in to the CLI, run
−
the enable and configure terminal commands in
sequence to enter the global configuration mode, and
run the protocol-mode sip command.
− To change to the MGCP mode, log in to the CLI, run
the enable and configure terminal commands in
sequence to enter the global configuration mode, and
run the protocol-mode mgcp command.
Q: How do I view the system information?
13.
A: For details, see Maintenance > Viewing the System
Information in the eSpace IAD Product Documentation.
Q: How do I set the VLAN priority on the IAD?
14.
A: For details, see Configuring the VLAN in the eSpace
IAD Product Documentation.
Q: How do I set the fax function on the IAD?
15.
A: For details, see Configuration in the eSpace IAD
Product Documentation.
Q: How do I enable the pulse dialing function?
16.
A: Log in to the CLI, and run the enable, configure
terminal, and advanced commands to enter the advanced
mode. Then run the pstnport attribute set 0 enable
command. If port 0 needs to be connected to the DTMF
phone, run the pstnport attribute set 0 disable command
to disable the pulse dialing function.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 FAQs
45