Special Set-Up Procedure - Column Bumper Installation - 3M 7000R Instructions And Parts List

13. Maintenance and Repairs
13.11 Special Set-Up Procedure -
3M-Matic 7000r-7000r3 Pro
™
Page 47
Column Bumper Installation
Purpose of Bumper Special Set-up
Procedure: Installing Column Bum -
pers restrict operating range of upper
assembly in proportion to box sizes
to be sealed (Figure 13-7A). This
installation limits working cycle time
resulting in increased operating speed.
Installation Instructions - Column
Bumper (A parts package is included
with the unit for installation purposes).
The Column Bumper will be located
on the column according to the size
of the box that is to be taped
(Refer to Figure 13-7A).
1. Raise and Lock the Upper Drive
Assembly.
Important: This procedure is for
authorized personnel ONLY!
2. Turn off air supply/electric power.
3. Remove Guard (see Installation
and Set-Up / Section 7), existing
holes/installing Column Bumper
should be visible.
4. Remove Column Bumper and set
screw parts package from carton.
5. Position Bumper as needed
(the recommended position is
shown in Figure 13-7A).
6. After the new Bumper is installed,
re-install the Safety Guard (see
Installation and Set-Up Section 7).
7. Turn "On" Electric Power/Pneu-
matics and press Station "Start"
Button.
* Important: See Figure 15983 for
Plate Change. When Column
Adjusted to "Raised" Position -
Part #30 is removed and replaced
by Part #12.
- Some bumper positions may:
1) Allow upper and lower taping
heads to come into contact
with each other.
2) Create added stress to the
bumper.
3) Cause malfunction of machine.
These events can potentially cause
damage to machine. For more infor-
mation on bumper settings, contact
your 3M service representative.
(continued)
• To reduce the risk associated with
- Read, understand, and follow all safety
- Allow only properly trained and qualifi ed
A
Safety Guard
Set Screws
& Washers
Shown is after Safety
( Guard is Removed)
Figure 13-7 Case Sealer Frame Changes
WARNING
mechanical and electrical hazards:
and operating instructions before
operating or servicing the case sealer.
personnel to operate and service this
equipment.
B
C
NA - ENG
April 2016