Special Set-Up Procedure; Drive Belt Height; Disassemble; Reassemble - 3M -Matic 800asb Instructions And Parts List

Special Set-Up Procedure

WARNING – Turn off electrical power
and disconnect power cord from
electrical supply before beginning special
set-up procedure, if power cord is not
disconnected, severe injury to personnel
could result.

Drive Belt Height

The drive belt assemblies can be raised 55 mm
[2.16 in] to provide better conveying of tall boxes.
This change increases the minimum box height
that can be taped to 115 mm [4.5 in].
DISASSEMBLE – Figure 5-1
1. It is first necessary to raise the top taping head.
Utilize the height adjustment crank and move
the upper taping head to the fully raised position.
2. Remove and retain the screw (A), cap washer
(B) and spacer (C) from the front and rear arm
assembly pivots.
3. Lift belt drive assembly (D) up off the arm
assembly pivots.
Note – Keep motor in vertical position to
prevent gear oil from leaking out of motor.
REASSEMBLE – Figure 5-2
4. Reassemble the spacer (C) onto the front and
rear arm assembly pivots first.
5. Install the belt drive assembly (D) onto the pivots
and secure with the cap washers (B) and screws
(A).
Note – Both drive belt assemblies must be
installed at the same operating height.
Figure 5-1 – Drive Belt Assembly, Disassembly
Figure 5-2 – Drive Belt Assembly, Reassembly
27